DC Output
12V - 8.3A
Sound Power Level
87.3dB(A)
Sound Pressure
66.4dB(A)
Protection
IP54
Overall Size (HxWxD)
365 x 360 x 330mm
Running time on full tank
5.8hrs
Net Weight
20.5kg
PLEASE NOTE:
This generator is not designed for continuous use.
FUEL MIXING
Take the plastic cup from inside the fuel filter to measure the amount of 2 stroke oil needed. Each mark
on the side equals the amount needed to mix with a litre of Petrol (1 full cup to every 4 litres). Using a
funnel, pour the fuel through the fuel filter into the tank.
PRE START-UP
DO NOT connect any electric apparatus to the generator prior to starting the
generator.
Make sure the ON/OFF switch is in the ON position Fig.5.
STARTING THE GENERATOR
Move the choke lever across to the left position Fig.6.
Make sure the fuel tap is in the ON - vertical position Fig.7.
Pull the recoil starter slowly until it engages with the drive mechanism, then
pull cord quickly to start the engine Fig.8.
After the generator has been running for a few seconds, return the choke
lever back across to the right. The engine should now idle comfortably.
Once the generator has settled down, connect the 240V appliance/Ext lead
to the 3 pin 240V outlet socket Fig.9 or the 12V battery charging lead to the
generator Fig.10.
DO NOT connect to both at the same time!
CIRCUIT BREAKERS
If either circuit breaker trips, the load on the generator is too great. Leave
for a few minutes to cool, then re-set the circuit breaker by pressing in and
make sure the load does not exceed the rated continuous output of 650W.
EXTENSION REELS
When a cable extension reel is used it should be fully unwound before being connected. Using a long extension
lead however will lower the power available from the Generator.
ELECTRICAL INFORMATION
SPECIFICATIONS
4
Model Number
GTS800
Order Code
OSA-273-3000K
Engine (2 stroke) Easy-start recoil
2.0hp
Displacement
63cc
Fuel - Oil ratio
50-1
AC Output
230V - 50Hz
Max. Output (peak power)
800W
Continuous Power
650W
Fig. 1
Fig. 2
TOOLS NEEDED:
Screwdriver supplied.
Remove the Generator from the packaging and the
accessories Fig.1.
Place the fuel filter in the fuel tank Fig.2.
Place the 2 stroke oil measuring cup in the fuel filter
for safe keeping Fig.3.
Place the cap on the fuel tank Fig.4.
Screw the handle onto
the top of the fuel tank,
placing the gaskets
between the handle and
the tank Fig.4.
ASSEMBLY
Fig. 3
Fig. 4
Fig. 11
5
Fig. 5
Fig. 8
OPERATION
Fig. 6
ON
Fig. 7
Fig. 12
Fig. 9
Fig. 10
OSA2733000K_Instructions.qxd 07/06/2010 13:08 Page 4
