Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
7. Secure all internal wires and replace cover and
7.
secure cover screws
8. Turn ON AC line voltage supply
9. If the unit is supplied with a line cord, connect the
9.
line cord plug into the appripriate receptacle
9.
previously installed
10. If unit is complete with lamp heads, positioning the
10.
lamp heads to provide best lighting distribution by
10.
loosening head set screws to adjust angle and
10.
swivel. Manually rotate or turn head(s) to the
10.
desired position then tighten set screws to
10.
lock position
Conduit Stem
(not included)
Conduit
(not included)
Fig.3
Fig.5
Fig.4
Fig.6
IMPORTANT
Circuit feeding unit MUST be protected by
lock-on breaker if breaker feeding this unit
does not have a lock-on device (warranty
will be voided if this is the case)
CAUTION
This equipment is furnished with a sophisticated low voltage battery
dropout circuit to protect the battery from over-discharge after the
useful output has been used. Allow 24 hours recharge time after
installation or power failure for full-load testing or usage.
OPERATION & MAINTENANCE
Operation
1. To test, depress the TEST switch. Charge indicator will go out
and the DC lamps will come on
2. Release the TEST switch. DC lamps will be extinguished and the
charge indicator will come on
3. A bright charge LED indicator light indicates a high charge rate.
After the battery has reached full charge, the indicator light will
go out. Under normal operation, the high charge indicator will
turn ON and OFF intermittently while the unit is in standby
mode (regular AC is present) since the charge rate will vary in
order to maintain an optimal battery performance
Maintenance
1. Code requires that the equipment be tested every 30 days
for 30 seconds and that written records be maintained for
all test results and repairs. Further the equipment is to be
tested once a year for the required duration as per Code.
The battery is to be replaced or the equipment repaired
whenever the equipment fails to operate as intended
during the duration test. The manufacturer strongly
recommends compliance with all Code requirements.
2. Clean lenses on a regular basis to provide maximum light
distribution in case of an emergency
IMPORTANT
The servicing of any parts should be performed by qualified service personnel only.
The use of replacement parts not furnished by the manufacturer may cause equipment failure and will void the warranty.
LED
Emergency Lights
MODEL
O
E-212BP
INSTALLATION GUIDE
INSTALLATION GUIDE
Hardwired Installation
Junction
Box
Crossbar
Lamp
head
Cabinet
Battery
Cover
Tilt
Rotate 180º
Circuit Board
LED Indicator
Green: AC ON
Red: Charge
Test
LED
Emergency Lights
MODEL
O
E-21
6-
150
W
