INSTALLATION GUIDE
ODDIN Supreme
Series
MODEL
ODD
IN
-
300
-3
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
Connect Electrical Wiring
Run 120V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach
the house
wiring to the wiring plate. Refer to the wiring diagram below, and connect the wires as shown.
Assembly Instructions
3.
.
Install duct work and junction box
Remove junction box cover and secure conduit or
stress relief to junction box knock-out hole.
Using connectors, connect house power wires to
ventilating fan wires (refer to the wiring diagram on
this page CONNECT ELECTRICAL WIRING section)
replace the junction box cover.
Squeeze the ductwork to fit the adapter then slip
onto the adapter and secure it with duct tape (not
included)
.
Run the ductwork to a roof or wall cap
(not included), secure all the ductwork connections
so that they are air tight.
Service Parts
Warning —
Before replacing, be
sure to turn OFF power
at power source.