WARNING
LED
Flush Mounts
MODEL
1101-5WH | 1102-7WH | 1103-9WH
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or
use of this product, consult a competent electrician.
INSTALLATION GUIDE
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY
A QUALIFIED
ELECTRICIAN.
1.
LED
Flush Mount
s
are suitable for
indoor use only
. DO NOT use outdoors
2.
Please keep the LED
Flu
s
h Mounts
a
way
from any corrosive substance
, and please use dry
cloth
when you clean them
3.
LED
Flush Mounts
can only be installed by a qualified electrician
4.
Before installation or maintenance, please disconnect the power
to prevent electric shock
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
CAUTION
Surface Mounting Installation
Application Notice
1.
This fixture is designed for use in a circuit protected by a fuse or circuit breaker.
It is also designed to be installed in accordance with local electrical codes.
If you are unsure about your wiring, consult a qualified electrician or local electrical inspector, and check your local electrical code
2.
For your safety,
turn off the power supply at the fuse or circuit breaker box before you install the fixture
3.
Ground the fixture to avoid potential electric shocks and to ensure reliable starting
4.
Double-check all connections to be sure they are tight and correct
5.
Wear rubber soled shoes and work on a sturdy wooden ladder
6.
RISK OF CUTS — some metal parts in the fixture may have sharp edges. To prevent cuts and scrapes, wear gloves when handling the parts
7.
RISK OF FIRE — Use 100-277V AC 50/60Hz circuits
8.
Account for small parts and destroy packing material, as these may be hazardous to children
9.
DO NOT change the LED light source or driver inside under any circumstance
10.
DO NOT cover the fixture with any heat insulated materials
11. All electrical connections MUST be in a accordance with local and National Electrical Code (NEC) standards
1.
Punching suitable hole on the ceiling
2.
Turn OFF the power supply, wire enter the ho
l
e of bracket, then fix the bracket on the ceiling with screws
3.
Connect LED body wires with power cord
4.
Push it towards the ceiling, and at the same time rotate it as direction of arrow,tightly fix the body and the mounting bracket
5.
Turn ON the power supply, if it normally light up, installation is complete
Installation of Bracket
1.
2
.
3
.
4.
5.
