Orolia Spectracom VelaSync 1232, User Manual

Page: 41 / 268

2.5 Basic Connections Setup
This section is designed to take your through the initial setup steps in order to allow you to
communicate with and configure your VelaSync.
Figure 2-4:
VelaSync rear panel
2.5.1 Connecting the GPS Antenna
For instructions on how to install a GPS/GNSS antenna , the signal cable , and accessories
such as surge protectors , weatherproofing kits , or amplifiers , refer to the Installation
Guide that came with the respective equipment.
For additional information regarding the GPS antenna location selection, see "Choosing a
GNSS Antenna Location" on page 233 .
1. Connect the GPS/GNSS antenna to the GNSS RF connector (see illustration above,
item number 7), using the supplied Type-N adapter cable, and an LMR-400 equi-
valent cable with surge suppressor and active GPS L1 antenna, such as Spectracom
model 8230.
Note the GNSS receiver connection provides 5V
DC
power for the antenna.
2.5.2 Connecting Power
Before connecting power to the unit, make sure that you have read all safety information
detailed in section
"YOUR SAFETY" on page 17 .
DANGER! When installing the product, use only the provided or designated
power cables. Using any other cables and adaptors could cause a mal-
function or a fire.
2.5 Basic Connections Setup
CHAPTER
2
•
VelaSync 1232 User Manual Rev. 4 29