4
(EN) Operation Instruction
TECHNICAL SPECIFICATION
Rated
Load
luminous
flux
color
temperatur
e
Light
color
CRI
(Ra)
Impact
protection
Size:
Net weight
Power
sourcing
Working temperature
OR-PL-6092WLPM4
12W
850lm
4000K
neutral
white
>80
IP20
250 x 260 x
60mm
0,42 kg
230V~, 50Hz
-20
0
C~40
0
C
OR-PL-6105WLPMR4
16W
1150lm
0,48 kg
light source:
detection range:
ambient light:
time delay: min. :
adjustable daylight sensor:
detection distance:
Lifetime LED:
Impact protection:
5730 SMD
360° (
ceiling mounting)
<3-2000 lux
10sek.±3sek.; max.3min±30sek.
ceiling
(max. Ø6m)
2,2 m do 4 m
50 000h
IK07
FUNCTION
Can identify day and night: The consumer can adjust working state in different ambient light. It can work in the daytime and at night when it is
adjusted on the “sun” position (max). It can work in the ambient light less than 3LUX when it is adjusted on the “moon” position (min). As for the
adjustment pattern, please refer to the testing pattern.
Time-Delay is added continually: When it receives the second induction signals within the first induction, it will restart to time from the moment.
Adjustable Tim
e Delay: the length of time delay could be set according to the customers’ requirement, the minimum time of this item is 10sec±3sec,
and the maximum is
3min±30sec.
DESCRIPTION
When choosing a mounting location, the following criteria should be taken into account:
- the lamp should be installed on a ceiling 2.2-4m high or on a wall 1.8-2.5m high,
- avoid installing close to heaters, fans or other devices which can cause sudden temperature change,
- avoid installing in places where sun rays are directly aimed at the motion sensor,
- do not place the lamp near objects that can be moved by strong wind (curtains or trees or bushes, etc.),
- make sure that the power cables have adequate current protection in form of appropriate fuses or other devices disconnecting power in the
event of overload,
- if there is a slight difference in temperature of the moving object and the ambient temperature (i.e. in summer), the sensor can react later and the
detection range will be reduced,
- do not mount near sources of strong electromagnetic interference,
- contamination of the sensor optics reduces the range and sensitivity of motion detection.
The device should be installed by an authorized electrician.
Do not install the lamp on uneven surfaces.
Do not place any object
s that could disrupt sensor’s operation in front of the device.
Do not open the luminaire once the power has been connected.
INSTALLATION
- Switch off the power.
- Unscrew the plastic screw nut and remove the PC lampshade.(refer to figure1)
- Pass the wire through the hole in the bottom and connect the power wire into connection-wire column according to the connection-wire
diagram. Install the sensor lamp in the position where you need with inflated screws. (refer to figure2)
- Switch on the power and test it
Figure.1a
Figure.1b
Figure.2
Figure.3
SENSOR INFORMATION
Figure.4a
Figure.4b
Height of installation: 2.2-4m
Detection Distance: Max.6m
