WITH 100% ULTRASOUND
13
Onlineshop: emmi-dent.com
Switching on and off
Switching on: Switch on the device by pressing the key (for ap-
prox. 1 second). Switch on. This emmi®-dent Go offers the func-
tion of switching the vibration motor and the position change
signal (signal tone/beep tone) off or on so that you can decide
whether you want to perform oral hygiene with or without the
vibration motor and the signal tone. To switch off the vibration
motor and the signal tone, please press and hold the On/Off
button for approx. 10 seconds. The LED lights up red four times.
To switch the vibration motor and the acoustic signal back on,
press and hold the ON/OFF key again for approx. 9 seconds.
seconds. The LED lights up green four times.
Switch off/Automatic switch off: Switch off the unit by
pressing the push-button (for approx. 1 second). The unit
switches off automatically after approx. 6 minutes (Battery
Save Function). The device is also provided with an electronic
sensor. If a wrong or defective Ultrasound brush head is used,
or no brush head has been inserted, the unit will also switch off
automatically and the green LED goes off after 1 second. If you
have forgotten the attachment on the handpiece for your trip,
the device will also switch off after approx. 6 minutes to prevent
discharging (Travel Safe function).
1 emmi®- dent Go hand piece,
1 emmi®- dent attachment for adults,
1 charging station,
1 tube ultrasonic toothpaste fresh(75ml)
Functions of the LEDs:
a) Charging control function LED
Red LED:
emmi®-dent incharging process
Green LED:
emmi®-dent is fully charged
b) Battery status (LED)
The LED is used as battery status
indicator during the cleaning process.
c) „Urgent recharge“ indicator
If the battery is heavily discharged, the
LED
flashes
red
a few times
after the cleaning process. Please charge the emmi®-dent.
d) Switching between vibration and acoustic signal (except
emmi®-pet)
If the On button of the emmi®-dent is pressed for approx.
10 se-
conds
, the
LED
flashes
red
and the vibration as well as the acoustic
signal are switched off.
Press and hold down the On button for approx.
10 seconds
, and
the
LED
flashes
green
. The vibration as well as the acoustic signal
are switched on now.
LED
