Imported by :
AIC International - 44980 Ste Luce sur Loire - France
Step 1: Charge the battery.
Plug the end of the USB cable into the slot provided (4) and then plug the other end of the cable into a
powered USB port (USB/ 230V adapter, computer...).
To turn on the meter: move the cursor (6) to the ON position. The display will light up quickly and beeps
will sound. The display then counts down for one minute to allow the unit to warm up and adjust. After
this time, all measurements are displayed.
Caution:
Do not make any adjustments during the countdown. The meter makes a slight noise. This is
normal and is related to the ventilation of the sensors during use. The noise stops when the meter is
turned off.
While the battery is charging, the icon above the time indicates the battery charge progress bar and
then goes out when the battery is fully charged. The meter will run for approximately 5 hours when the
battery is fully charged (excluding USB connection). The battery charging time will vary depending on
the USB power mode used. We recommend leaving the meter connected to USB to allow continuous
measurements.
Caution:
To recharge the battery, the meter must be plugged in and in the ON position. The battery
does not charge in the OFF position.
Step 2: Place the meter
It is recommended to place the meter in the living room, bedroom, meeting room, etc. on a piece of
furniture and to choose a location that allows the sensors (7) to remain unobstructed in order to ensure
proper operation of the device.
Ideally place the meter in the centre of the room and at least one metre away from the walls or ceiling
of the room. Keep away from any direct source of pollutants, liquid products, heat, flammable products
and magnetic fields.
Step 3: Adjustments and settings.
Press and hold the button
(3) until the 12H or 24H time format flashes.
Select with the "
+"
and "
-"
buttons (5). Then press the button (3) briefly to confirm and move on to the
next setting.
The time
flashes → select with keys (5) → press (3) to confirm.
The minutes
flash → select with keys (5) → press (3) to confirm.
The alarm time
flashes
→ select with keys (5) → press (3) to confirm.
The alarm minutes
are flashing → select with keys (5) → press (3) to confirm.
The
temperature
unit format
flashes → select °C or °F with keys (5) → press (3) to confirm and
exit the setting mode.
1
: Display of information.
2
: Touch button for backlighting.
3
: Button for the settings menu and to confirm.
4
: Battery charging adapter port.
5
: "+" and "-" buttons
6
: "OFF" and "ON" button
7
: Locations of sensors and fans.
