O WN ER' S MA NUA L - 3
END PANEL LAYOUTS
help compensate for timing differences between drivers.
3. Level Control (Channels 1 & 2 / 3 & 4) - continuous adjustment
for full power output
4. RCA Input (Channels 1 & 2 / 3 & 4) - accepts Low Level RCA
Inputs (200mV-4V) from a head unit, preamplifier, or equalizer.
5. RCA Line Output - provides easy connection to additional ampl-
ifiers. Note that some OEM stereo headunits may sense the
attached load and may turn off their speaker outputs if expected
load conditions aren’t achieved
6. Remote Gain input - connects remote gain control to control the
bass level from the driver’s seat.
7. High pass filter (Channels 1 & 2 / 3 & 4) - adjusts the frequency
of the crossover for the HPF (High-Pass Frequency Control ,
XTR500.4,XTR750.4 and XTR1000.4 : 50Hz - 5kHz ,
XTR1700.4 and XTR2500.4 : 50Hz-1.5kHz/500Hz-15kHz)
8. X-Over (cross-over Channels 1 & 2 / 3 & 4) - activates LPF (low
pass crossover), Full (all pass), or HPF (high pass crossover)
9. Low pass filter (Channels 1 & 2 / 3 & 4) - adjusts the frequency of
the crossover for the LPF (Low-Pass Frequency Control ,
10. Variable High pass filter X10 Feature - XTR1700.4 and
XTR2500.4 50Hz-1.5kHz(Without pressing a button)/
500Hz-15kHz(press a button).
50Hz -400Hz)
11. Power connection input
*
NEGATIVE(GND)
- power return connection. Connect this
terminal directly to the sheet metal chassis of the vehicle, using
the shortest wire necessary to make this connection. Always use
wire of the same gauge or larger than the (+) 12 volt power wire.
The chassis connection point should be scraped free of paint
Figure 1
1. Bass Boost (Channels 1 & 2 / 3 & 4) - continuously adjusts
from 0 to 18dB of boost centered at 45Hz
2. Phase Shift Control (Channels 1 & 2 / 3 & 4) - Allows you to
change the phase of your subwoofer from 0 to 180 degrees to
XTR500.4,XTR750.4 and XTR1000.4
XTR1700.4 and XTR2500.4
.
.
