●
Two-channel or four-channel input can be used for this configuration. For source
unit fading, use the four-channel input mode.
●
Front and rear outputs can be configured for high-pass, low-pass or full-range
operation.
●
Rear outputs are configured for summed bridged operation for subwoofer appli-
cations.
●
Only the rear speaker is controlled when using the RGC-1.
Tri-Mode Six Channel Configuration
●
Lowest recommended impedance is 2
W
stereo and 4
W
bridged mono.
●
Front and rear outputs must be set for full range operation.
●
Passive crossovers must be used on all components and frequencies must not overlap.
●
Only the rear speaker is controlled when using the RGC-1.
WARNING!
Failure to observe these requirements may result in damage to the amplifier.
10
©2004 Directed Electronics, Inc.
