Orion ORION MaxxBass, Owner'S Manual

Page: 10 / 17

2. Dual Stereo Configurations
For systems without rear subwoofers, the user may prefer to use two
Maxx Bass ®
Processors, one for the front speakers and one for the rear
speakers. The units should be wired between the in-dash CD Receiver and the
power amplifiers as shown below.
NOTE: As an option, before beginning, disconnect the
negative (-) terminal of the battery to prevent an electrical
short to ground. Reconnect the negative terminal only after
all connections have been made.
WIRING PROCEDURES
The next step is to connect the Power, Ground, and Remote IN/OUT wires to
your
Maxx Bass
®
Processor. The power wire should run from the mounting
location through the vehicle to the battery or power distribution block.
Avoid sharp corners, creases, and sharp body parts. When passing through
any metal wall (i.e. firewall, etc.), a grommet must be used to prevent the
wire from chafing and shorting to ground.
Front Rear
Maxx
Bass
®
In-dash
CD Receiver
Power
Amplifiers
Maxx
Bass
®
Front speakers
with Virtual
Subwoofer TM
LF
RF
Rear speakers
with Virtual
Subwoofer TM
RF
RR
9