http://www.orion.ua
4
“Sleep”: The fan runs for half an hour on strong then soft natural wind mode, then changes to
soft natural wind for the next half hour, and then the fan turns off automatically.
(1).Setting H:
Operation pattern: H
→
Stop
→
H
→
Stop
→
H
(2).Setting M:
Operation pattern: M
→
stop
→
M
→
Stop
→
M
(3)Setting L:
Operation pattern: L
→
Stop
→
L
→
off
→
L
*Press “
SWING
” to start oscillation; press again to fix the airflow direction.
*Press “
HUMIDITY
” to start the humidifying function; mist comes out of the front plate if there is
water in the tank.
The MIST function can be used on its own or along with the fan function to blow the mist into
the room.
*Press “
TIMER
” button to make the fan run for the length of the timer. There are 4 indicator
lights for automatic timing. To set a time of 7.5 hours
you need to press 15 times and all the 4
indicator lights light up.
* The Remote Control must be pointed towards the Remote Sensor on the main unit for best
results. If the remote control doesn't operate as expected, replace the batteries (2 pcs, AA
battery).
Caution
* Do not touch / pull out / put back the water tank when the unit is plugged into a power source.
Make sure it is physically disconnected from the mains before doing anything with the water
tank.
* When the water level is too low, the safety switch will cut out operation of the mist function.
Unplug the unit and refill the water tank for further operation.
* Do not let dust or other particles collect on the mist plate - if the mist outlets are blocked, the
mist function could malfunction.
* Before cleaning the unit, make sure it is completely disconnected from the power source.
Make sure your hands are not wet when unplugging the unit.
* Do not use very hot water in the water tank - use water less than 40 degrees Celsius.
* Use only water in the water tank. Do not add chemicals
or
oils or any other additive.
* Infants,the disabled and the elderly should not be in the
direct airflow from the fan for long periods of time.
Cleaning and Maintenance
* Make sure power is disconnected before any
cleaning or maintenance is performed.
* It is recommended that you clean the water
tank every 2-3 weeks of use, and clean the
flume every week.
* Pull out the water tank before cleaning it - pull
the plastic tube out of the mist cask properly,
then take out the mist cask and water tank.
* Use a dry cloth to clean the mist cask. If there
are stubborn stains on the mist cask, use a cloth
lightly dampened with mild detergent.
* If the mist feature will not be used for a long
time, empty the water tank and leave it to dry
before recapping it.
