13
4.2 Operating Mode
Normal range mode: Under Input mode the UPS accepts AC input voltage range for +20% ~ -25%.
Generator mode: Under generator mode, the low frequency transfer point can go as low as 40Hz and as high as
70Hz before being transferred to battery mode.
Wide range mode: Under Input settings mode, the UPS accepts AC input voltage range for -30% ~ +30%.
Battery mode
When the UPS is operating during a power outage, the alarm beeps once every four seconds and the LCD
display string shows “bATT” to indicate the UPS work at battery mode.
If battery volume becomes low while in Battery mode, the alarm beeps once every second and the LCD display
string shows “bATL”.
Standby mode
When the UPS is turned off and remains plugged into a power outlet, the UPS is on Standby mode. The LCD
display string shows “STbY” to indicate that power is not available to your equipment. The battery recharges when
necessary.
4.3 Configuring Load Segment
- Load segment are sets of receptacles that can be controlled through the display.
Each UPS has two configurable load segments. See “Rear Panels” on page 26 for load segment for each UPS model.
LS3 are main outlets and cannot be configured, only follow ON/OFF switch. Note: This configuration can be operated
when UPS is power on.
To configure the load segment through the display:
1.
Enter settings mode:
Press and hold the Enter button
more than 3 seconds. Then UPS will transfer to
setting mode.
2.
Select settings items:
Press the Select button
to select the setting items show as Table 5.
3.
Enter settings item:
When the LCD display “LS1” or “LS2”, press the enter button
more than one second to
enter the setting item and the settings string will flash.
4.
Select setting value:
Press the Select button
to select the settings value. Select the value [001] or [000] to
set the desired load segment ON or OFF.
5.
Confirm settings:
Press and hold the Enter button
for one second, ups will return to current setting item.
6.
Exit Settings mode:
Press and hold the Enter button
for 3 seconds or button
for 0.5 second to exit setting
mode.
4.4 Configuring UPS for EBM Numbers
- To ensure the LCD displays the correct battery volume, configure the UPS for the correct number of EBMs:
1.
Enter settings mode:
Press
more than 3 seconds to enter setting mode.
2.
Select settings items:
Press
to select setting items as “EbM”.
3.
Enter settings item:
Press
more than one second to enter the setting item.
4.
Select setting value:
Press the Select button
to select the number of EBM according to your UPS
configuration.
5.
Confirm settings:
Press and hold the Enter button
one
second, ups will return to current setting item.
6.
Exit Settings mode:
Press and hold the Enter button
for 3 seconds or button
for 0.5 second to exit
setting mode.
4.5 Configuring Green Function
- Green Function is that when an insignificant amount of load is detected, the UPS will shut down output automatically
on battery mode. The green function is disabled on default mode and user can configure Green Function through the
display:
1.
Enter settings mode:
Press
more than 3 seconds to enter setting mode.
2.
Select settings items:
Press
to select setting items as “GF”.
3.
Enter settings item:
Press
more than one second to enter the setting item.
4.
Select setting value:
Press the Select button
to select “001”.
5.
Confirm settings:
Press and hold the Enter button
for one second, ups will return to current setting item.
6.
Exit Settings mode:
Press and hold the Enter button
for 3 seconds or button
for 0.5 second to exit
setting mode.
