Programming preset stations
You can also preset stations of your choice and store up to 10 AM and 10 FM stations
in its memory. To store your selected broadcasting stations:
1. Press the STOP / BAND button to toggle between AM and FM to make your selection.
2. Tune to the required station.
3. Press the MEMO / C-ADJ button.(F.11)
4. Press the REPEAT / M-UP button to your desired station number.(F.12)
5. Press the MEMO / C-ADJ again to confirm your selection.
6. To program more stations into memory, repeat the above steps 2 to 5.
7. To change the stored preset stations, repeat the above steps 2 to 5.
Notes:
1. In the radio mode, when frequency is displayed, this button is use for setting of memory writing
enable state for 10 seconds.
2. Storing a new station into a preset location will erase the previously stored station in that
location.
3. Power off / failure or power cord disconnection will clear the memory of all preset stations.
Perform the stations presetting procedures again to store the stations.
Selecting the Preset Stations
1. Press the STOP/BAND button to select the desired AM/FM stations.
2. Press REPEAT/M-UP button to select the desired preset station number.
3. The numeric location of that preset station is displayed along with the corresponding frequency.
FM Antenna
Locate the FM antenna wire for better FM reception.
F.11
F.12
UK-5
