UK-3
AC CORD
INSTALLING THE SYSTEM
OPERATING THE UNIT
POWER/STANDBY
CLOCK SETTING
TIMER SETTING
1.
Speakers Connection
Extend the SPEAKER WIRES and connect them
to the SPEAKER TERMINALS.
2.
Power Cord Connection
Before using , connect the AC Power Cord to
the AC outlet , then turn on the main switch
of the unit.
When you first plug the unit into the AC outlet , the
unit will be in standby mode , You can press the
STAND-BY button on the unit ( or on the remote control )
to switch the unit ON and OFF. Pull the AC plug out of
the wall socket if you want to switch off completely.
1. Press the STAND-BY button on the unit (or remote) to switch the unit on.
2. Select the sound source ( CD , TUNER or AUX ) by pressing corresponding function key.
The corresponding display will light up. (Note: Use remote pressing FUNCTION key selection)
3. Adjust the volume with the VOLUME ( UP or DOWN ) button.
4. Set the present equalizer ( classic , rock or pop) with the EQ button on the remote.
5. Press the STAND-BY button again to switch off the unit.
Unit on STANDBY position
1. Press & hold MEMORY / C-ADJ. button until time display 24-hour digit flash.(F.1)
2. Press TUNING / SKIP / SEARCH UP or DOWN button to adjust 24-hour or 12-hour digit.(F.2)
3. Press MEMORY / C-ADJ. button again, time display hour or minute digit flash, press TUNING / SKIP /
SEARCH UP or DOWN button to adjust hour or minute digit. (F.3)(F.4)
4. Press the MEMORY/C-ADJ.button again to confirm the clock setting.
1. Press the POWER / STANDBY button to put the machine in the standby mode, check standby is lit.
2. Briefly press the MODE / REMAIN button , the "TIMER " symbol will flash. Each enable state as
shown above is cleared when the key is not pushed for 10 second. While the "TIMER " symbol is
flashing, press the MEMORY / C-ADJ button for 3 seconds the hour digits flash. Press on one of the
TUNING/SKIP buttons to set the hour. Press the MEMORY/C-ADJ button, the minute digits flash.
Press on one of the TUNING/SKIP buttons to set the minutes. Press the MEMORY/C-ADJ button
again to validate the time. The "TIMER " symbol switches off. (F.5) (F.6) (F.7)
3. Press TIMER button (on the remote) to validate the timer function. The activation time for the timer is
shown for a few seconds, then the machine again displays the actual time.
4. In the TIMER ON mode, the initial volume level is equal to last turn off volume level.
F.1
F.3
F.4
F.2
A
C
M
A
IN
P
O
W
E
R
S
W
IT
C
H
R
R
L
L
R
R
L
L
