4
Figure 2
Figura 2
Abbildung 2
Rear/Trunk
of Car
Rear Seat
STEP BY STEP INSTALLATION
Step 1: Determine where the speaker will be mounted. Make sure there is a
flat area large enough for the speaker to fit properly. An uneven
mounting surface can damage the driver.
Step 2: Check to make sure the space you have chosen for the speaker will
not interfere with the operation of the vehicle.
Step 3: Using a template, mark the speaker hole with a pen.
Step 4: Cut the hole for the speaker. When using factory locations, this step
can be passed. A hole can be cut either with a pair of metal tin snips
or a hole saw corresponding to the size of the speaker listed below.
s MM HOLESAW
s MM HOLESAW
Step 5: Run the speaker wire to the speakers. Make sure to keep wires away
from sharp metal or other edges. When passing through metal ,use a
protective grommet.
Step 6: Using the template, mark the mounting holes with a pen.
3TEP 0REDRILLMOUNTINGHOLESUSINGA
1/
8" drill bit.
Step 8: Pull the wire through the speaker opening and connect to the
speaker.
Step 9: Mount the speaker and grill in the hole using the same screws. Insert
the screws through the grill and the mounting holes in the basket.
WARNING: Window mechanisms and electrical wires may be hidden
from sight. CHECK FOR CLEARING BEFORE YOU DRILL!
@2012 MD Audio Engineering-all rights reserved