OR-7200ED User’s Manual
2
• Please use only the power cord supplied with the product. Use of other power cords may result in fire and electric shock.
• In case of smoke, smell or noise, immediately turn off the power switch and remove the power cord from the power outlet. Continued operation of the
product may result in fire and electric shock. Request a maintenance service from the authorized system vendors or installers.
• If the product is dropped or damaged, turn off the power switch and remove the power cord from the power outlet. Continued operation of the product
may result in fire and electric shock. Users should request a maintenance service from the authorized system vendors or installers.
• Do not touch the product with wet hands. Doing so may result in electric shock.
Risk of serious or lesser degree of injury.
May also cause damage to the product or to property.
• Do not leave the power cord or other cables in passageways. Passers-by may trip and fall.
• Avoid contact with water or beverages. Contact with water or beverages may result in damage that cannot be repaired.
• In case of lightning, immediately turn off the power switch and remove the power cord from the power outlet. The product may otherwise be damaged.
• Excessive current from the product and the camera may result in an electric shock. Connect the power cord to an external device only when the products
themselves are disconnected from their power supply.
Risk of minor injury or damage.
• If a foreign substance is stuck to the product, remove it using a soft cloth or tissue. Do not use chemical agents (thinner, solvent, etc.) to remove the
substance.
• Do not operate or store the product in the following places.
- An area that is either too cold or too hot
- An area of high humidity, or in front of an air-conditioner, or in places subject to sudden temperature changes
- An area where there is excessive dust
- Areas where heat from the product cannot be emitted through both of the product's side ventilation openings
• Do not place credit cards/telephone cards/bank account books/tickets and other objects with magnetic properties near the product.
• Static electricity may cause damage to the internal parts of the product. Please remove static electricity from your body before touching the rear panel
and internal electronic parts of the product.
• If this product is damaged beyond repair or reaches its maximum service life, dispose of it in compliance with local laws and regulations regarding the
disposal of lead and plastic waste.
Requirements or limitations regarding operation. Users are
recommended to read the relevant details carefully so as to operate
the product properly and without harm.
• The product may not work properly if the power source is unstable or and if electric shock occurs. Make sure the correct rated power is available.
• The product is designed to be proof against electric power failures; however, damage may occur as a result of power failure. Current data may be
damaged or data might not be recorded. Make sure to use an Uninterruptible Power Supply (UPS).
• Since the product is designed to record video data on the hard disk, an error in the hard disk or other miscellaneous errors might prevent the product
from recording properly. Periodic maintenance is required for proper operation of the product.
• The product is designed for users to configure their own interface. However a user configuration error could lead to operation malfunction. This product
should be set up by certified installers only.
• Since the product is connected - and tightly coupled - to exterior accessories (camera, sensor, LAN, Hard Disk, etc.), there is a risk of malfunction from
external causes. Ensure periodic maintenance by the certified installers.
• Use the rack mounting handle provided with the product for installation.
• In this product, 1 Kbyte equals 1,024 bytes, 1 Mbyte equals 1,048,576 bytes and 1 Gbyte equals 1,073,700,000 bytes.
