3.2
Press the programming pushbutton once for a moment
.
The red luminous diode begins to
flash very slowly (2 seconds on, 2 seconds off). However, if the luminous diode starts flickering
, an opening key was already put in at the selected storage location. The set storage location
has to be deleted first. See
„Deleting an opening key or a programming key“.
3.3
Any RFI key is taken to the reading area
.
The red luminous diode begins to flash faster. But,
if the red luminous diode only begins to flicker, this RFI key was already assigned to another
number. Then this key must either be deleted or another one has to be applied.
3.4
The RFI key is removed from the reading area
.
The red luminous diode flashes for
acceptance once for a moment and once for a longer time. Now the RFI key is put in as
opening key.
Deleting an opening key or a programming key without manual terminal
Please read first!
1. Set the turn switches to the number which was assigned to the RFI key to be deleted.
2.
Press the programming pushbutton once
for a moment and then once again and keep it
pressed.
The red luminous diode flashes three times and keeps flashing constantly.
3.
When the red luminous diode flashes constantly, stop pressing the button.
The red luminous
diode flashes once for a moment and once for a longer period to demonstrate acceptance. Thus, the
RFI key memorized under this figure is deleted. If you do not stop pressing the pushbutton, after a
few seconds the luminous diode starts flickering. Then you may let the pushbutton off without
deleting the RFI key. You may also avoid a deleting of the RFI key if you let the pushbutton off
while the diode is flashing.
To delete a key it must not necessarily be available but, lost keys can also be blocked.
Modification of operational adjustments
The following adjustments of operation may be done:
All entered keys attract relay No. 1.
The keys assigned to odd numbers (1-3-5) cause relay No. 1 to be attracted and the even ones (2-4-6)
attract relay No. 2 (only on type RFI 1000-2)
Setting the relay-operating time (impuls length)
Feeding the manual terminal, RFI Master
Deleting manual terminal RFI Master (Becomes necessary, if another or a new terminal shall be
applied.)
Deleting of all storage locations
Setting jumper A brings the device into adjusting mode. Now each pressing of the programming
pushbutton causes the luminous diodes to show what may be modified. After pressing, let it off
again. As long as you keep on pressing the pushbutton, the red luminous diode keeps on flickering.
The modification becomes effective as soon as the jumper is removed again. Then the device
changes to its normal working order.
Setting jumper A:
The red luminous diode keeps beaming constantly.
If the jumper is taken off
again, no change to the adjustments takes place.
First pressing of the pushbutton
:
The green and the red luminous diode are beaming.
If the jumper
is taken off now, all keys fed in cause relay 1 to attract.
Second pressing of the pushbutton
:
The red, the green and the yellow luminous diode are beaming
.
If the jumper is taken off now, the keys fed in to odd storage locations (1-3-5...), cause relay 1 to
attract. The keys entered in even storage locations (2-4-6...) cause relay 2 to attract.
