Abridged version : „Entering a key“
1. Set the number with the turn switches.
2. Press the programming pushbutton once for a moment
or
hold the program key on to the reading
device ( 1 sec. approx.) and remove it again.
3. Hold the RFI key parallel to the reading device (1 sec. approx.) and remove it again.
Now the RFI key is entered under the adjusted number.
When the just entered RFI key is held to the reading device again, the relay must attract now. Should
this not be the case, please read the detailed version of the operating instructions and repeat the action.
Entering the RFI key without manual terminal
1
Entering the programming key
The programming key is a key „0„ is assigned to.
A programming key may serve to put the device into „entering position“ thus, it is not
necessary to press the programming pushbutton on the printed-circuit board. It is not absolutely
necessary, but may perhaps simplify the operation.
1.1
Put both turn switches to „0“ position
1.2
Press the programming pushbutton once for a moment
.
The red luminous diode starts
flashing very slowly (2 seconds on and 2 seconds off). But, if the luminous diode starts
flickering, a programming key was entered already and has to be deleted first. See
„
Deleting a
programming or an opening key
“.
1.3
Any RFI key is taken into the reading area
.
The red luminous diode starts flashing faster.
However, if the red lumious diode only begins to flicker, this RFI key has already been
assigned to another number as an opening key. Then this key must either be deleted first or
another one must be applied.
1.4
The RFI key is removed from the reading area
. The red luminous diode flashes once for a
moment and once for a longer while to demonstrate acceptance . Now the RFI key is put in as
programming key.
2
Entering opening keys by means of the programming key
2.1
The turn switches are put to the number which shall be assigned to the RFI key
,
(not to
„0“), odd number for relay No. 1, even number for relay No. 2 (only on model RFI 1000-2).
2.2
The programming key is brought to the reading area.
The red luminous
diode starts
flashing.
2.3
The programming key is removed from the reading area
.
The red luminous diode starts
flashing very slowly (2 seconds on, 2 seconds off). However, if the luminous diode starts
flickering, the selected number was assigned to another opening key. The opening key assigned
to this number first has to be deleted. See
„Deleting an opening key or a programming key.“
2.4
Any RFI key is brought to the reading area
. The red luminous diode starts flashing faster.
However, if the red luminous diode only begins to flicker, this RFI key was already assigned to
another number. Then, this key either must be deleted or another one has to be used.
2.5
The RFI key is removed from the reading area
.
The red luminous diode flashes once for a
moment and once for a longer time to demonstrate acceptance. Now the RFI key is put in as
opening key.
3
Entering an opening key without programming key
3.1
Set the turn switches to the number, the RFI key shall be assigned to.
(not to „0“)
