5
S O U N D B A R I N STA L L AT I O N US E R M A N UA L
Once the mounting screws are installed and the wire hole has been drilled it is time to
run the wires. The SB3 Soundbar requires three pair of speaker wires while the SB1 and
SB.5 LCR will have an individual pair for each speaker. Each pair will have a positive (+)
and negative (-) connection. Your speaker wire should have an indication along the wire to
differentiate between the two. Make sure you use the same wire to connect to (+) and (-) on
both the speaker and the amplifier/receiver. Also make sure you connect the appropriate
channel, Left, Center and Right, on both the speaker and the amplifier/receiver. If not, the
positional steering of the movie soundtrack will be incorrect.
(See diagram 4)
Strip the insulation ½” from the end of the wire. Run the speakers out of the hole in the wall
and use the connectors to attach the correct wires to the speaker terminals. The terminals
operate by pushing them in and inserting the wire through the hole on the side of the
terminal. After the wire is inserted, release the terminal and the spring-loaded mechanism
will lock the wire in place. Make sure the insulation is not inserted into the hole in the
terminal as it will not allow the wire to make a connection.
WIRING
DIAGRAM 4
Left Center Right
