Step 3
Use the semi-assembled side-bar to determine the correct position
on the boat. Bear in mind the height in the boat, the windscreen
window, additional tower accessories, wiring etc… When you have
determined the correct position mark the position on the masking
tape using the mounting brackets. !Make sure the tube joints are
mounted completely level (on a flat spot)
! TIP : start +/- 20cm in front of the windscreen to determine the
correct position. This for possible mirror mount on the tower.
Step 4
After marking one side you can mark the other side using the
mounting brackets. Make sure to mark the deck mounts on the
direct opposite of the boat using fixed points of reference on the
boat.
Step 5
Keep in mind you are going to be placing backing plates and need
access to fit a wrench to tighten the nut on the deck mount bolts on
the inside of your boat. Before drilling inspect the inside of these
locations for obstructions such as wires or cables. You are now
ready to drill the holes. When drilling in fiberglass first use a pilot bit
size 6 than a drill bit size 14. After drilling the 4 holes, it is
Summary of Contents for Catapult
Page 7: ......
