6
Parts list & tools required
P A R T S S U P P L I E D
q
Ultra plinth, 4 small rubber feet and 4 nails
q
Lid, (usually fitted 2 off Lid hinges bottom & 2 top, 4 off M4 x 10mm bolts, 4 off M4 nuts, 4 off M4 brass
washers).
q
Bag – Belt, 2 off cable clips (small & large), 6 off no 6 x ¾” screws, Bag - 3 springs / 3 long M5 bolts / 3
spring seats / 3 rubber washers / 6 off M5 brass washers / 9 off M5 serrated washers / 6 off M5 nuts
q
Platter
q
Sub-platter
q
Main bearing house on sub-chassis / Oil
q
Motor with fitted pulley – (attached)
q
Sub-chassis ( MDF damper arm & spring plates, glued washers)
q
Power supply 230 volt or 110 volt (delete one)
q
DC regulator board / switch
q
Upgrade Transformer (optional)
q
Sliding VTA adjuster, Aluminium sleeve, allen set screw (optional)
q
Threaded VTA adjuster and packing washer (optional)
q
Arm (optional)
P A P E R W O R K
q
Turntable instructions
q
Power supply instruction sheets
q
Strobe card
q
Upgrade transformer sheet (optional)
T O O L S Y O U W I L L N E E D I D E A L L Y
§
Ruler or measuring tape
§
Marker pen.
§
Small hacksaw or powerful snips
§
Cross head screwdriver
§
3mm or 3.5mm drill
§
Pliers or molegrips
§
Hammer
§
Soldering iron (not essential)
§
Spirit level
