DANGER:
If the alarm sounds, and smoke alarm is not being tested, the smoke alarm is sensing
smoke. THE SOUND OF THE ALARM REQUIRES YOUR IMMEDIATE ATTENTION AND
ACTION.
MAINTENANCE AND CLEANING
In addition to weekly testing, this smoke alarm requires yearly battery replacement and periodic cleaning to
remove dust, dirt, and debris.
BATTERY REPLACEMENT
Always turn off the AC supply to the smoke alarm before replacing the battery. Replace battery at least
once a year or immediately when the low battery signal sounds once a minute, even though the smoke
alarm is receiving AC power. Batteries should be replaced regularly as necessary.
WARNING:
Do not use any other type of battery, except as specified in this manual.
Do not use rechargeable batteries.
CAUTION
:
Explosion will happen if battery is incorrectly replaced.
You’d better use good battery to make the alarm work long.
The battery should only be replaced by a qualified electrician or similarly qualified person.
1. Turn off AC power supply to the smoke alarm.
2. Turn smoke alarm counterclockwise to detach it from the mounting plate.
3. Gently pull down smoke alarm.
4. Remove battery from the compartment.
5. Insert a new 9-volt battery to connector. NOTE POLARITY OF CONNECTIONS. Ensure the metal tab
is fully depressed when the battery has been fitted.
6. Using the Push-to-Test button, test the smoke alarm to verify 9V DC battery back-up.
See
“
TESTING THE SMOKE ALARM
”
7. Reattach the smoke alarm to the mounting plate by turning smoke alarm clockwise until it snaps into
place.
8. Turn on power supply and test smoke alarm using push-to-test button.
See
“
TESTING THE SMOKE ALARM
”
CHOOSING A REPLACEMENT BATTERY:
The unit requires one standard 9V battery. The following batteries are acceptable as replacements:
Megaton #6F22; New Leader #6F22; Gold Peak #1604; Eveready #522, #1222;
Golden Power G6F22; Golden Power GL6F22A
CLEANING
Clean the smoke alarm at least once a month to remove dust, dirt, or debris. Using the soft brush or
wand attachment to a vacuum cleaner, vacuum all sides and cover of smoke alarm. Be sure all the
vents are free of debris.
If necessary, use a damp cloth to clean smoke alarm cover.
IMPORTANT:
Do not attempt to remove the cover to clean inside the smoke alarm. This will void
your warranty.
PRACTICE FIRE SAFETY