Changing Monitor Settings
126
Portable Bedside Capnograph/Pulse Oximeter
CO
2
Parameters
Institutional Defaults can be set for all CO
2
parameters that are settable in the monitor. To change the
parameters, select
CO
2
in the Institutional Defaults screen.
Parameter
Choices
Factory Default
CO
2
Units
mmHg, kPa, Vol%
mmHg
BTPS*
On/Off
On
FiCO
2
Display
On/Off
On
Pump-Off Timeout (minutes)
5, 10, 15 or 30
15
CO
2
Waveform Scale (mmHg)
50, 100, 150, Auto
Auto
EtCO
2
Scale for Trend Display
50, 100, 150
50
RR Scale for Trend Display
50, 100, 150
50
Sweep Speed Adult/Pediatric (mm/sec)
3, 6.3, 12.5, 25
6.3
Sweep Speed Infant/Neonatal (mm/sec)
3, 6.3, 12.5, 25
6.3
* BTPS denotes the standard correction used during measurement for body temperature, pressure, and saturation.
BTPS should be set to ON during all measurement procedures. The device automatically turns off the BTPS
correction during calibration procedures and turns it on again following these procedures. There is no need for the
user to make any changes to the BTPS setting.
SpO
2
Parameters
Institutional Defaults can be set for all SpO
2
parameters that are settable in the monitor. To change the
parameters, select SpO
2
in the Institutional Defaults screen.
Parameter
Choices
Factory Default
Pulse Tone
On/Off
Off
Sat-Seconds
On/Off
On
SpO
2
Scale for Trend Display
0-100, 50-100
50-100
PR Scale for Trend Display
150, 300
150
Sweep Speed Adult/Pediatric (mm/sec)
3, 6.3, 12.5, 25
25
Sweep Speed Infant/Neonatal (mm/sec)
3, 6.3, 12.5, 25
25
