25
Scan Resume Time
If 5,10,or 15 sec is selected, signal will start again after 5,10, or 15
second pause even though a signal is still present.
If P5 is selected, SCAN will stop as long as a signal is present and will
resume SCAN again 5 seconds later.
Key Lock
To prevent accidental entries, you can lock the keypad.
Press up or down key button until “key lock” appears in the display.
To unlock the keypad, press up or down key in key lock function
selected in menu mode.
When the key lock is active, a warning beep will be heard if you
attempt to press keys (except for the PTT button).
Factory Reset
If the radio's display locks up or stops functioning properly, you might
need to reset your UHF radio.
Caution : This procedure clears all the information you have stored in
your UHF radio.
Before you reset your UHF radio, try turning it off and on again.
If your UHF radio is still not functioning correctly you may need to reset
the UHF radio.
To reset Press and Hold Monitor and power on. “Reset” will appear in
the display. The radio will then return to standby mode.
TOT (Time of Timer)
Australian and New Zealand standard require that if the PTT is pressed
for more than 3 minutes the unit must stop transmitting. The radio is
set to stop transmitting after 2 minutes and 30 seconds of continuos
transmission. “TOT-on” will appear in the display and it will emit a beep
sound to indicate that TOT is activated.
Operations
OR 010610 Renew UHF5500 user manual.indd 25
2014-5-8 13:21:55
