Call
- 9 -
4. Slide the base unit down into place.
GREETING YOU WITH “HELLO”
At first start up, your handset welcomes you with a “Hello” message. At the “Hello” screen, set the country to start using the phone.
The Country menu is only available in models that support multiple-country settings. If the model has only one country setting, the “Hello” message will
not be available and therefore you will not need to select the country setting before use
.
Selecting your country
It is necessary to select the correct country for the phone to work properly according to your country’s standards.
At the “Hello” screen,
1. Press
>>
to navigate to your country.
2. Press
OK
to confirm. Your phone is now ready to use.
To re-configure your country setting, see page
44
.
WHAT IS STANDBY MODE?
Your phone is in standby mode when it is idle. The standby screen displays the handset name, the date and time, the signal icon, and
the battery icon.
REGISTERING YOUR HANDSET
Registration allows communication between your base unit and handset(s). If your handset cannot communicate with its base, you will
not be able to make any call or use some of the functions and features on the phone.
To register your handset to an additional base unit, see
Registering your handset(s) with additional base
on page
44
.
If your handset displays NOT REG, follow the steps below to register your handset.
1. Press
REG
. REGISTER shall be highlighted.
2. Press
OK
to confirm selection.
3. Select the base number you want. Press
OK
. This base number will be assigned to the base unit you are about to register
to.
4. Enter the system PIN. Use
DELETE
to make correction.
5. Press
OK
to confirm. Your handset starts searching for the base.
6. Press
PAGE
on the base unit for 4 seconds. The registration process shall be completed within 30 seconds. If registration
is successful, the signal icon displays steadily. If registration failed, repeat the above procedure.
CHECKING THE SIGNAL STRENGTH
The signal icon displays the link status between your handset and the base unit.
Steady signal icon: Your handset and base unit are linked. They can communicate.
Flashing signal icon: Your handset and base unit have lost link. They are not able to communicate. Take your handset closer to the
base unit to reconnect the link.
NOTE:
Your base can register up to 9 handsets. After registering 9 handsets, your base unit registration
memory is full. If you attempt to register an additional handset, you will hear a reject tone from the base.
The registration process will be aborted.
NOTE:
Your S209 Twin pack handsets are registered at the factory. Follow the procedure below only if you
have bought extra handsets or you have de-registered a handset.
Summary of Contents for S209
Page 2: ......
