26
Help
8. Help
Attempting to repair the baby monitor will void the warranty.
Display
No display
• Try recharging the battery pack.
• Reset the Units. Unplug the power from both parent and camera units,
then plug them back in.
• Press and hold the ON/OFF button
0
on the Parent Unit for 3 seconds to
switch it ON.
• Check that the correct camera is selected, change the camera number, if
needed.
• Is the video display turned on? Press the VIDEO ON/OFF button
V
to
turn it ON.
• When operating using battery only, the display will go turn off after 5
minutes, 15 minutes, or 30 minutes to save power (depending on video
settings). The Unit is still active and will give you audio alerts. You can
reactivate the screen by pressing any button.
Registration
If the Baby Unit has lost its link with the Parent Unit
• If the Baby Unit is too far away it may be going out of range, so move the
Baby Unit closer to the Parent Unit.
• Reset both the Parent Unit and Baby Unit by disconnecting them from the
electrical power. Wait about 15 seconds before reconnecting. Allow up to
one minute for the Baby Unit and the Parent Unit to re-connect.
• See 2.3 Registration (Pairing), if there is a need to re-register the Units.
Interference
Noise interference on your Parent Unit
• Your Baby and Parent Units may be too close. Move them further apart.
• Make sure there is at least 1 to 2m between the 2 Units to avoid audio
feedback.