ORGA L85EX, Installation And Maintenance Manual

Page: 29 / 72

Version 2.1 29
TROUBLESHOOTING
1. Open the cover assembly, see section
2
.
2. Check if the electrical connections in the
housing are tight.
•
Connection to terminal L (+).
•
Earth connection PE.
•
Connection to terminal N (-).
•
Earth connection (A) in the housing.
3. If necessary, correct the connection(s).
4. Switch on the mains power supply.
5. Check if the LED’s function.
•
If yes, switch off the power supply and
close the lighting fixture.
•
If not, check the power supply from
the control panel.
6. On the control panel, turn the mains power switch to the ON position.
7. Check if the LED’s function.
•
If yes, switch off the power and close the lighting fixture.
•
If not, replace the control unit.
8. Close the cover assembly, see section
2
.
4.3 Replace the dome
1. Connect the live wire from the cover
assembly with terminal -.
Apply a torque of
minimum 0.75 and maximum 1.25 Nm.
2. Connect the neutral wire with te.
Apply a torque of minimum 0.75 and
maximum 1.25 Nm.
3. Connect the earth wire with terminal M.
Apply a torque of minimum 0.75 and
maximum 1.25 Nm.
4. Connect the second earth wire (A) to the
earth connection (B).
5. Close the lighting fixture. Refer to
2
.
N(-)
PE
L(+)
A
B
WARNING
Only use cable lugs of the eyelet type.
Note
Do not strip the insulation of the wiring more than is necessary.
+
m
-