Oregon Scientific SE836, User Manual

Page: 13 / 64

E
N
•
you maintain a continuous and moderate walking and
running speed
•
you complete walking and running the set distance
10. While calibrating, your watch will show a flashing “CAL”
like the screen below. This means calibrating is in
progress. Do not stop by pressing
SET unless you have
completed the set distance.
11. After completing the set distance, press SET to stop
calibration.
Ø
If calibration is successful, the watch will display
Run parameter
or
Walk parameter
NOTE
The Run parameter and Walk parameter is the
value to enter when inputting parameter.
Ø If calibration fails, the watch will display
If you want to re-do calibration, press SET and repeat
steps 8-11. Make sure there is battery power in the
watch and chest belt, and the chest belt you are wearing
is the one paired with the watch (check device ID in
Device Mode) and is positioned securely across your
chest.Otherwise, press
MODE to exit.
INPUTTING PARAMETER
You can only know your parameter if you have already
successfully calibrated by running or walking beforehand.
This is because the parameter is the same value displayed
after you have successfully calibrated by running or walking.
By inputting parameter, you will be spared the time of
calibrating by running or walking again.
. Press MODE repeatedly to select .
2. Press SET .
3. Press ST/LAP/+ repeatedly to select “ CAL DEVICE ”.
4. Press SET .
5. Press ST/LAP/+ to select “ PARA INPUT ”.
6. Press SET to confirm selection.
7. Input parameter for Walk by pressing ST/LAP/+ to
increase values or - / SP to decrease values. The
parameter is the same value after you have successfully
calibrated by walking.