5
GB
SIGNAL will stop blinking. The strength of the reception
for the last full hour will be indicated.
- Unit has received radio signal.
- Clock is searching for radio signal but not yet
received. It is recommended that you reposition or
rotate the antenna.
- The display time has been manually set and is not
synchronized to the RF signal.
- Radio reception is disabled and no signal reception
will be initiated until it is enabled again.
- When the antenna symbol blinks, a reception is going
on. A full reception takes approx. 2 to 10 minutes,
depending on the quality of the signal received.
The hourly scanning may take a few seconds only.
No indicator
For better reception, place the clock away from metal
objects and electrical appliances to minimize interference.
If you wish to disable the auto-reception feature, press the
[
] BUTTON for three seconds. The RADIO RECEP-
TION SIGNAL will disappear. The unit will not respond to
radio signals.
To enable the feature again, press the [
] BUTTON for
three seconds. The RADIO RECEPTION SIGNAL will
start blinking to initiate reception automatically.
HOW TO SET THE CLOCK
MANUALLY
To set the clock, hold [MODE/SET] for three seconds. The
display will return to MODE 1, with the hour digits
blinking.
Use [
] or [
] to select the hour. Keep pressing the
button will increase or decrease the value rapidly.
Press [MODE/SET] to confirm. The minute digits will
blink. Repeat the same procedure to set the minutes, then
the day-of-month, month, display language, day-of-week
and offset for the second time zone.
Note that the time and date are displayed in 24-hour clock
and DAY-MONTH format, respectively. For display lan-
guage, you can choose among English, French, German and
Italian--in that order. Day-of-week is the usual sequence of
Monday through Sunday.
For the second time zone, which is indicated by the ZONE
ICON, enter the hour offset and the RM318P will calculate
the second time accordingly.
If there is an item you do not wish to change, simply press
[MODE/SET] to bypass the item.
When you are done, press [MODE/SET] to exit. The
display will return to the mode last chosen.
