EN
Outdoor measurements are collected by the remote
unit.
Temperature is give at the top; humidity is below.
VIEW MIN / MAX / CURRENT MEASUREMENTS
Press
SELECT
3 times until the Temperature and
Humidity Areas flash. Press
UP
or
DOWN
to scan the
readings.
CLEAR MIN / MAX MEASUREMENTS
While viewing Min/Max measurements, press and hold
UP
or
DOWN
for 2 seconds until a beep sounds. This
clears the previous measurements from the memory.
SELECT REMOTE UNIT CHANNEL
While in the Temperature / Humidity Mode, press
CHANNEL
to switch between CH 1, 2, or 3, or press
and hold
CHANNEL
for 2 seconds to enter Auto scan
mode. If only 1 remote unit is in use, you will not be
able to change channels or Auto scan. If you select
“Auto”, the channel will change every 3 seconds. To
deactivate, press and hold
CHANNEL
for 2 seconds
again.
SENSOR SEARCHING
If there is no remote unit signal, the temperature and
humidity measurement will be blank. Check the remote
unit batteries, or press and hold
UP
and
DOWN
for 2
seconds to search for the remote unit(s).
15
PS-L03_GB-final.p65
8/8/03, 12:15 PM
17
