E
N
G
L
I
S
H
4
O
perating
I
nstructions
To Operate
Make sure disposable paper filter dust bag is in place. DO NOT
operate the cleaner without a paper filter dust bag. Plug the
power cord into an electrical outlet and press the On
(l)
- OFF
(O)
switch on Helping Handle Assembly.
General Information
The performance of your new cleaner greatly depends upon care
and maintenance. The instructions in this manual will guide you in
performing basic care and maintenance. To obtain the most
satisfying years of service, read the instructions and keep them
handy for future reference.
Operating Recommendations
This new ORECK XL High-Speed Upright is one of the finest,
fastest, and strongest units in its class. You’ll love the way it
cleans, gets under things, and it’s SO lightweight and easy to
use.
The following are a few simple suggestions regarding its
operation:
1. When inserting a new disposable paper filter dust bag—
FIRST PUFF OUT and OPEN THE BAG.
2. When the disposable filter dust bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or
makes an unusual noise, STOP OPERATION and service.
4. Although your upright will pick up pins, paper clips, and
other small objects, it is recommended that these be
removed from the floor before you vacuum. Failure to do so
may result in permanent damage to the motor suction fan
and its housing.
5.
WARNING:
Do not use your vacuum cleaner on damp or
wet surfaces. This will cause damage to the vacuum cleaner
and is dangerous to the user. Damage caused by use on wet
or damp surfaces is not covered under warranty.
A
ssembly
1
2
3
4
9
10
11
14
15
12
13
5
6
7
8
To assist you in identifying
components of your vacuum,
the parts have been numbered
as follows:
1 Handle section, upper
2 Tube, lower
3 Power head
4 Outer bag
5 Paper filter dust bag
6 Power cord
7 Retaining spring
8 Bag tension bar
9 Zip fastener
10 On/off switch
11 Cord hook
12 Plastic loop/cable clamp
13 Connector assembly/
cord wrap
14 Fan housing
15 Cord assembly
Upper
Handle
Connector
Assembly
With ON/OFF switch facing
the front of the unit, slide
upper handle section over
matching section of the
connector assembly. Hold
handle brace against upper
handle and align screw
holes. Insert short screw into
top hole and long screw into
the bottom hole then tighten
firmly until handle is no
longer loose.
1
Before assembling appliance,
remove two screws from the
connector assembly. Remove
cardboard insert by pulling
upward.
2
Attach cord to cord clip by
pressing cord above and
below clip ensuring the cord
is fully rested in clip.
3
