Before assembling appliance,
remove two screws from
connector assembly. Remove
cardboard insert by pulling
upward
(fig 1)
.
With ON/OFF switch facing the
front of the unit, slide upper
handle tube over matching
section of the connector
assembly. Hold tab of cord
strain relief flush with
TOP
hole in connector assembly. Insert
screw through hole in tab of cord strain relief and firmly tighten
to connector assembly. Insert remaining screw in bottom hole of
connector assembly and tighten firmly
(fig 2)
.
NOTE: The power cord comes installed in the cord strain relief.
Should the power cord come loose, simply pinch the power cord
together and slide approximately 1 - 2 inches through hole in
cord strain relief. Carefully slide power cord over clamp on the
cord strain relief and pull excess until the power cord is tightly
rested under clamp.
Attach cord to cord clip by pressing cord above and below clip
ensuring the cord is fully rested in clip
(fig 3)
.
2
4
Assembly
Assembly
To Replace Paper
Filter Dust Bag
WARNING: Unplug cord from
electrical outlet before servicing.
To assist you in identifying
components of your vacuum,
the parts have been numbered
as follows:
1 Handle tube, upper
2 Tube, lower
3 Power head
4 Outer bag
5 Paper filter dust bag
6 Power cord
7 Retaining spring
8 Bag tension bar
9 Zip fastener
10 On/off switch
11 Cord hook
12 Plastic loop/cable clamp
13 Connector assembly
14 Fan housing
15 Cord assembly
16 Cord Strain Relief Assembly
1
2
3
4
9
10
11
14
15
16
12
13
5
6
7
8
1
3
BAG REMOVAL:
1. Unsnap bag door from base.
2. Gently pull bag from
cardboard collar upwards.
3. XL2605HH: Dust seal will
close automatically
BAG INSTALLATION:
1. Slide the cardboard collar
completely onto bag dock
door.
2. Firmly push bag dock door
with both thumbs on
indication point until
it snaps.
ENFONCEZ JUSQU’À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN
TAB
