OPERATION
Unpacking and Initial Operations
Open shipping box (both sides). Remove
packaging material. Roll machine out of box.
Pre-Run Inspection
Before each use, inspect for cracks, tears or
excess wear. If the machine or accessory is
dropped, inspect for damage. Then repair or
replace, if necessary, before use.
1 -
Tilt head back and place the foot of
bumper on the ground. Choose a pad for the
appropriate application.
2 -
Center the pad on driver plate.
3 -
Then position handle in a lower position.
4 -
Push slowly forward until machine base
tilts towards the ground.
CAUTION
Make sure to put the wheels back on the ground
in time to avoid the base from falling on the
ground. This might cause damage! Check that
the power switch is in the “off” position.
Battery Charging & Installation
Ensure battery is charged before using machine.
•
(FIGURE A)
Disconnect the battery cord.
•
(FIGURE B)
Loosen Velcro strap on battery.
•
(FIGURE C)
Retract the battery handle and
with two hands, lift battery carefully and pull
away from machine.
To reinstall the battery, reverse the steps
above.
CAUTION
VERY IMPORTANT TIP!
ALWAYS FULLY CHARGE BATTERY
IMMEDIATELY
after each use!
DO NOT STORE DISCHARGED BATTERY!
RESULT:
Will VOID battery warranty!
Always check the battery Velcro strap is
tightly secured before operating the machine.
9
1
2
3
4
FIGURE A
FIGURE B
FIGURE C
