Orbitalum REB 14, Operating Instructions Manual

Page: 7 / 40

Operating instructions REB 6, REB 14, REB 20 1 Notes on safety
orbitalum tools gmbh
(06.10)
MT_REB 6_REB 14_REB 20_BA_04_790093762_02.doc
3
1 Notes on safety
The Pipe End Preparation Machine (in the following referred to as REB) is a
state-of-the-art machine. Using it for purposes other than those described in
this manual may cause injury to the user or to others. The machine or other
equipment may also be damaged.
Therefore:

Always ensure that the machine is in good working condition, and always
comply with these notes on safety.

Keep the complete documentation close by the machine.

All regulations generally valid for the prevention of accidents must be
observed.
1.1 Proper use

Use the REB only for preparing (beveling, squaring) of pipe ends made
from metallic materials (see chapter 3.2, p. 11).

The user will be the only person liable for damages caused by improper
use.
1.2 Safety regulations

Only use the dimensions and materials specified in this manual. Always
consult Orbitalum Tools after-sales service personnel before using other
materials.

Only use original Orbitalum Tools spare parts and auxiliaries.

Inspect the REB every day for visible signs of damage or defects.
Any damage or defect must be repaired immediately.

Work on the electrical equipment may only be performed by a qualified
electrician.

Only operate the REB (E) if both electrical protection devices, disable re-
start and overload protection, are in proper working order.

Disconnect the REB (E) from power supply before changing the tools or
carrying out maintenance and repair work and allow the machine to come
to a stop.

Operate the REB (D) only by the ON/OFF switch on the twist grip for speed
regulation.