7 Operation
Operating instructions REB 6, REB 14, REB 20
26
(06.10)
MT_REB 6_REB 14_REB 20_BA_04_790093762_02.doc
orbitalum tools
gmbh
7.7
Preparing the tube
Hot and sharp chips!
Danger of injuries to eyes and hands.
Always wear safety goggles when working.
Don't remove chips without wearing hand protection.
Only use the cooling cutting material KSS-TOP as recommended by Orbitalum
Tools for chip removal. Machining with lubrication extends the service life of
the multifunctional tools and larger feed rates are possible.
1. Use the feed supply (1) to drive the tool up to the pipe.
1
2. Advance very carefully until the first contact is made between pipe and tool.
When the cutting edge of the tool machines-down over the whole circum-
ference of the pipe, advance forwards with a uniform pressure.
Compressed air drive:
If you reduce the advance (with the advance supply)
you must also reduce the cutting speed (using the twist grip for regulation of
the speed).
Regulation of the set speed by the controls for
electrical drive
is independent
of the load.
REB (D):
Danger of injury! The compressed air valve (ON/OFF grip) could be
actuated inadvertently so that the machine is started.
Switch off the machine after completing each stage of work and allow the
machine to run a stop.
DANGER
Note
Note
WARNING
Summary of Contents for REB 14
Page 39: ......
