tublr sideways
medium/mini
installation manual
4 / 4
Enjoy your beautifully lit room
11
Orbit NV · Schoonmansveld 35 · Parcel 522 · 2870 Puurs-Sint-Amands · Belgium
T +32(0)3 844 45 33 · [email protected] · orbit-lighting.com
IMPORTANT LED
INSTALLATION RESTRICTIONS
• Use only power supplies that are certifi ed
according to the applicable IEC or UL safety
standards.
• Use only SELV power supplies and check the
ratings of the power supply with those of the
luminaire.
• The maximum current rating must be taken
into account.
• The indicated typical voltage must not be used
to select a constant voltage power supply but
is indented to be used to select a constant
current power supply that is able to cover that
typical voltage.
• In case the luminaire is already equipped with
a power supply, the luminaire may only be
used with this power supply.
• Take appropriate ESD measures. Avoid
touching bare conductors.
• LED’s or LED luminaires that require a
current controlled power supply must never be
connected in parallel.
• LED’s can be damaged by the contact with
certain chemicals or chemical gasses.
• Therefore led domes or led engines should
never be cleaned with chemical substances.
• The following substances have
proven to have a negative infl uence on the
performance and must not be used in the
direct environment of a led luminaire: Methyl
acetate or ethyl acetate (i.e., nail polish
remover),
Cyanoacrylates (i.e., “Superglue”), Glycol ethers
(including Radio Shack® Precision
Electronics Cleaner - dipropylene
glycol monomethyl ether), Formaldehyde or
butadiene (including Ashland PLIOBOND®
adhesive), Dymax 984-LVUF conformal
coating, Loctite Sumo Glue, Gorilla Glue,
Bleach, Bleach-containing cleaners and sprays,
Loctite 384 adhesive, Loctite 7387
activator and Loctite 242 thread locker
• Remove insulation and/or provide suffi cien
ventilation so that the indicated max Tc is not
surpassed.
• LED’s are susceptible to switching transients.
Therefore switching must be done in the
primary circuit of the power supply.
• Orbit recommends to use the power supplies
that are indicated in the Orbit Catalogue.
• Respect polarity in order not to damage
the LED’s.
• Don’t test LED luminaires one by one on a
power supply that is switched on.
CE standard / CE norm / Norme
CE / CE norm
850°C
Glow wire tested / Gloeidraadtest /
Essai au fi l incandescent / Glühdraht
geprüft
Fixation ceiling / Plafondbevestiging
/ Montage au plafond / Deckenbe-
festigung
Fixture class 1 / Toestel klasse 1 /
Appareil classe 1 / Gerät klasse 1
IP20
Protection level / Beschermindi-
catie / Indice de protection /
Schutzkennziff er
Suitable to be mounted on
normally fl ammable ooden surfaces
/ Monteerbaar op brandbare houten
oppervlakte / A utiliser en surfaces
normalement infl ammables en bois
/ Montierbar auf feuergefährlichen
holzoberfl ächen
Al
Aluminum / Aluminium / Aluminium
/ Aluminium
0,5m
Minimum distance lamp - object /
Minimale afstand lamp - object /dis-
tance minimal ampoule - objet / Min-
imum entfernung leuchtmittel - objekt
Correct disposal of this product
(waste electrical & electronical equip-
ment) / Correcte verwijdering van dit
product (Elektrische en elektronische
afvalapparatuur) / Comment éliminer
ce produit (Déchets d’equipements
électriques et électroniques) / Ko-
rrekte entsorgung dieses produkts
(Elektromüll)
