Orbit JETRONIC-BOX – Manual 1.2
2:RC-CONTROL – Settings for the Inputs RC1 and RC2
20:RC1-MODE
Specifies the input function for the remote control input RC1.
NORMAL
:
Standard remote control input, ON
≥
1.65 ms, OFF
≤
1.25 ms
REVERSE
:
Inverted remote control input, OFF
≥
1.65 ms, ON
≤
1.25 ms
Default setting:
NORMAL
21:RC1-PRESET
Specifies the power-on setting for the remote control input RC1.
Use this to avoid accidental retraction of the landing gear when turning on the receiver or
transmitter. On the display, this is indicated by a
*
at the RC1 status.
ON
:
The remote control signal / the switch must first be set to ON.
OFF
: The remote control signal / the switch must first be set to OFF.
Default setting:
ON
22:RC2-MODE
Specifies the input function for the remote control input RC2.
OFF
:
Remote control input RC2 disabled
NORMAL
:
Standard remote control input, ON
≥
1.65 ms, OFF
≤
1.25 ms
REVERSE
:
Inverted remote control input, OFF
≥
1.65 ms, ON
≤
1.25 ms
POS.-SWITCH
: Position switch input for the position "gear retracted" active
ANALOG-IN
:
Measurement of a voltage between 0 and 2.5 V (additional function)
The two outermost pins (-) and (pulse) are used.
Default setting:
OFF
23:RC2-PRESET
Specifies the power-on setting for the remote control input RC2.
Use this to avoid accidental retraction of the landing gear when turning on the receiver or
transmitter. On the display, this is indicated by a
*
at the RC2 status.
ON
:
The remote control signal / the switch must first be set to ON.
OFF
: The remote control signal / the switch must first be set to OFF.
Default setting:
OFF
11
