Carefully position fan for
shortest duct run and
fewest elbows to achieve
maximum performance.
Grille assembly
Fig.8
Lighting assembly
Ceiling board
Fluorescent lamp
Fig.7
Motor assembly
Motor assembly
Ceiling board
Ceiling board
Fig.6
1.000
D series
EP series
Roof
Vent
Duct
2
1
3
3
5
6
4
4
9
8
7
7
Fig.4
90
Elbow
Wall
Cap
Roof
Vent
Duct
Horizontal run
Horizontal
to vertical
run
1
5
4
4
2
8
9
9
10
5
Fig.5
1 5/8
5/8
2
5
6
1
4
7
8
4” termination (duct)
Rough Opening:
L 10-3/4” x W 10-3/4”
Housing Dimension:
L 10-5/8” x W 10-5/8” x H 7-5/8”
1. For new fan installation position the
housing in the attic next to the ceiling
joist or truss.
2. Trace housing bottom edge on ceiling
material for cutout.
3. Confirm the opening, then cut hole
1/16 larger than the housing edge all
around.
4. Place housing in the opening with
allowance so bottom edge will fit flush
to the finished ceiling.
5. To attach follow steps 3, 4, 5 for New
Construction.
Existing Construction
Housing
Sliding
bracket
Three
prong
plug
Two
prong
plug
Lamp
body
Grille
Fig.3
Lamp
cover
Tube
Termination & damper
Duct
Housing
Grille
Ceiling
Sliding bracket
Screws
Joist
Housing bottom flange
Bracket mount
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
1. Remove grille from housing before installation.
2. Insert pair of sliding brackets in each bracket mount.
3. Locate housing between ceiling joists or truss so bottom flange will fit flush
to the finished ceiling. Note: sliding bracket to bottom flange = 3/4. Sliding
bracket end tab is 1/4, align with joist bottom for 1/2 ceiling sheetroc.
4. Loosely screw to joist through the mounting bracket KEYHOLE slots
(screws not provided).
5. Confirm housing alignment for ceiling finished thickness then tighten keyhole
screw. Note: housing must be flush with the finished ceiling for the grille to
fit properly. Add a screw in the hole above the keyhole slot.
6. connect the house power wires to wires of the product according to the
wiring diagram.
7. Insert the motor assembly into the housing and secure the motor unit to the
housing by screw (M5X12) (Fig.6)
8. Fix the lighting assembly into the housing by screws (Fig.7). And then insert
the 18 watt fluorescent lamps into the lighting assembly .
9. Insert the grille springs into the slots of the casing and mount the grille unit.
Finish the installation work .(Fig.8).
READ AND SAVE THESE INSTRUCTIONS
