CP 97132
12
3. Slide the rod down through the pin and insert the wires through the tube.
4. Mount the ceiling support using 2 screws and washers.
5. Make sure that the hook on the base fits correctly with the groove of the dial.
6. Insert the receiver of the remote control as shown in the image.
7. Connect the power supply cables to the ceiling support strip, respecting its corresponding polarity:
phase-phase, neutral-neutral, earth-ground.
8. Attach the bowl to the ceiling support, aligning the side holes and secure it by tightening the screws
9. Insert the connectors securely. Place the LED board in the light kit and it will stick magnetically.
10. Install the ceiling light on the lamp by turning it clockwise.
OPERATING THE FAN
§
Select the fan speed by pressing the speed control button on the remote control transmitter :
HI: High Speed MED : Medium Speed LOW : Low Speed OFF : Off
§
Program the fan for 1, 2, 4 or 8 hours by pressing the corresponding button and the fan will stop
working after the selected time has elapsed.
§
Pressing the ‘ON/OFF’ light button on the remote control transmitter can control the turning on or
off of the light.
The motor housing switch varies the direction of rotation of the blades and thus controls the direction of air
movement.
Caution: Before using this direction of rotation switch, turn off the fan and make sure the fan stops rotating
to avoid injury and damage to the motor.
When it's cold: Press the "UP" switch and the blades will direct warm air trapped near the fan down the
entire room.
When it's hot: press the "DOWN" switch and the propeller blades will create a breeze that will spread
throughout the room
MAINTENANCE
TO CHANGE THE LIGHT PLATE
1. Switch the appliance off (it is advisable to also switch off the circuit-breaker or breaker).
2. Remove the plug and remove the LED board.
3. Take a new LED board. Insert the connectors securely. Place the LED plate in the light kit.
4. Reset the power supply and turn on the lamp.
