ST 6100 Terminal Installation Guide
R9015 Version 03
10
© ORBCOMM
®
Proprietary
Blunt Cut Cable
This cable connects the ST terminal to external I/O lines and serial ports. There are 10 pins on this blunt cut
cable; two connect the terminal to an RS-232 console serial port or an RS-485, four wires to connect to external
I/O lines, and one each for ground and voltage. The cable has an over-molded connector, a floating drain wire
and is available in two models, either terminated or unterminated to ground.
Specifications
Parameter
Value
Part Number: ST301005
Cable drain wires (outer shield and I/O
–
Figure 22) terminated to ground at
ST terminal connector (PIN 3
–
Figure 21).
Part Number: ST301025
Cable drain wires unterminated/not connected (outer shield and I/O
–
Figure 22) to ground.
Length
5 m, 10 m, and 25 m
For additional lengths, contact your Account Executive.
Temperature
-40°C to +85°C (-40° to +185°F)
Ultraviolet rating
UV stabilized
Figure 21 Face View of Terminal Blunt Cut Cable Connector
Table 1
Terminal Mating Blunt Cut Cable Color Code
Position
Color
Wire Gauge
Functionality
1
White
22 AWG
RS-485_A
2
Grey
22 AWG
RS-485_B
3
Black
20 AWG
Ground
4
Red
20 AWG
VIN (Vbatt)
5
Green
22 AWG
I/O 02
6
Blue
22 AWG
I/O 03
7
Brown
22 AWG
I/O 01
8
Purple
22 AWG
I/O 04
9
Orange
22 AWG
RS-232 Tx (output)
10
Yellow
22 AWG
RS-232 Rx (input)
