Oral-B TRIUMPH 5000, Instruction

Page: 6 / 88

7
• The flashing green lights indicate that the tooth-
brush is charging (picture 1, page 5); once it is
fully charged, the lights turn off. A full charge
enables up to 10 days of regular brushing (twice
a day, 2 minutes).
• Note: If the green lights do not flash immediately,
continue charging. They will appear in 10–15
minutes.
• If the rechargeable battery is low the red low
charge indicator light is flashing for some seconds
when turning your toothbrush on/off. If the
rechargeable battery is empty the motor will stop;
it will need a 40-minute charge before you can
use it for a 2-minute brushing.
• You can check the charging status for some
seconds by turning your toothbrush on/off or
placing it on the charging unit.
SmartGuide adjustments
The SmartGuide (i) comes with a demonstration
mode activated. Deactivate this mode by removing
the battery compartment cover in the back (picture
A, page 4) and push the «set» or «h/min» button. A
flashing «12:00» indicates that you can now adjust
the clock time.
Clock Time
Press and hold the «set» button until «12h» is
displayed. By briefly pressing the «h/min» button,
you can toggle between «12h» or «24h» daytime
format. Push «set» to confirm your choice. Then the
hour digit starts flashing. Press the «h/min» button
until the right hour appears and confirm with «set».
Proceed same way to set both minute digits (picture
B, page 4). If you prefer not using the clock feature,
the flashing «12:00» will disappear automatically
after 24h.
SmartGuide Icons
Displayed
Icon Meaning
«Daily Clean» mode
«Deep Clean» mode
«Sensitive» mode
«Whitening» mode
«Massage» mode
Too much pressure is applied.
Reduce the brushing force.
«Quadrant circle»
Move to the next quadrant of your
mouth when the relevant segment
flashes.
You reached the dentist recom-
mended 2-minute brushing time
(3-minute brushing time within the
Deep Clean mode).
You will receive a star with each
completed quadrant.
Smart Guide Batteries are low.
Change batteries of the SmartGuide.
Using your toothbrush
Brushing technique
Wet brush head and apply toothpaste; you can use
any kind of toothpaste. To avoid splashing, guide
the brush head to your teeth before switching the
appliance on (c).
Guide the brush head slowly from tooth to tooth,
spending a few seconds on each tooth surface
(picture 3, page 5).
Start brushing the outsides, and then the insides
and finally the chewing surfaces (picture 3, page 5).
Brush all four quadrants of your mouth equally.
In the first days of using any electric toothbrush,
your gums may bleed slightly. In general, bleeding
should stop after a few days. Should it persist after
2 weeks, please consult your dentist or dental
96183085_D34_CEE_S6-92.indd 7 06.02.13 10:58