Oracle Talari T860, Hardware Manual

Page: 17 / 18

Oracle Talari T860 Hardware Guide
pairs are configured as “fail-to-wire” by default.
Bypass mode is used when the APNA is not powered on, when the APNA is powered on but is
not configured, or when the APNA is powered on and configured but the Talari Service is
disabled. When the T860 APNA is in bypass mode, one or both of the bypass LEDs will stop
blinking Green.
Please also see the section above, “
Important Note About Cabling and Bypass
Mode
”
Problem Resolution
Bypass mode blocking traffic
Verify that the T860 APN appliance has connectivity to the L2/L3
devices on its LAN/WAN ports. Verify that the correct cables are
used and that the networking devices have auto-negotiate set
for their ports.
T860 stays in bypass mode
Confirm that the T860 is configured properly and that the
Talari Service is enabled.
1 5