Installing the Switch
99
9. Consider your next step:
■
(Optional) Display and record the fabric cards FRU ID information.
See
“Identify the Fabric Card Addresses” on page 99
.
■
Power on the line cards.
See
“Enable the Line Cards for Installation” on page 102
Related Information
■
Switch Command Reference
,
showpresent
command
■
Switch Command Reference
,
checkpwrfault
command
■
Switch Command Reference
,
checkvoltages
command
■
Switch Command Reference
,
checkfans
command
■
Switch Command Reference
,
checkswitches
command
■
Switch Command Reference
,
getfwversion
command
■
“Power On the Fabric Cards for Installation” on page 96
■
“Verify the CMC Status” on page 86
■
“Verify the Power Supply Status” on page 89
■
“Verify the Line Card Status” on page 104
■
“Check Link Status” on page 116
▼
Identify the Fabric Card Addresses
1. Identify the prerequisite and subsequent tasks you must perform in
conjunction with this procedure, to install the switch.
See the table in
“Installation Sequence” on page 20
2. Use this table to provide the IPMB address for a fabric card in a particular slot.
Slot Number
IPMB Address
(in hexadecimal)
0
94
1
96
2
98
3
9A
4
9C
5
9E
6
A0