Oracle SPARC T7-1, Installation Manual

Page: 75 / 88

Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)
5.
In the left navigation panel, click on Host Management → Power Control.
6. Select Reset from the pull-down menu, and click Save.
7. In the left navigation panel, click on Remote Control → Redirection.
8. Select Use Serial Redirection, and click Launch Remote Console.
As the host resets, messages are displayed in the serial console. The reset activity takes a few
minutes to complete. When the
ok
prompt is displayed, continue to the next step.
9.
At the
ok
prompt, boot from the appropriate boot media for your installation
method.
For more information, refer to the Installing Oracle Solaris 11 Systems , comparing installation
options at:
http://www.oracle.com/goto/solaris11/docs
For a list of valid boot commands that you can enter at the OpenBoot prompt, type:
{0} ok help boot
boot <specifier> ( -- ) boot kernel ( default ) or other file
Examples:
boot - boot kernel from default device.
Factory default is to boot
from DISK if present, otherwise from NET.
boot net - boot kernel from network
boot cdrom - boot kernel from CD-ROM
boot disk1:h - boot from disk1 partition h
boot tape - boot default file from tape
boot disk myunix -as - boot myunix from disk with flags "-as"
dload <filename> ( addr -- ) debug load of file over network at address
Examples:
4000 dload /export/root/foo/test
?go - if executable program, execute it
or if Forth program, compile it
10. During the installation, supply the configuration parameters as directed.
See “Oracle Solaris OS Configuration Parameters” on page 76 .
Related Information
■
“Configure the Preinstalled OS” on page 71
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 72
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 74
■
“Assign a Static IP Address to the NET MGT Port” on page 77
Powering On the Server for the First Time 75