Oracle SPARC T7-1, Installation Manual, Page: 73 / 88

Reach a State to Install a Fresh OS (Oracle ILOM CLI)
Are you sure you want to reset /System (y/n)? y
Performing reset on /System
4. Switch communication to the server host.
-> start /HOST/console
Are you sure you want to start /HOST/console (y/n)? y
Serial console started. To stop, type #.
The server might take several minutes to complete POST, and then the OpenBoot prompt (
ok
) is
displayed.
5. Boot from the appropriate boot media for your installation method.
For more information, refer to the section on comparing installation methods in Installing
Oracle Solaris 11 Systems that corresponds to your desired release at:
http://www.oracle.com/goto/solaris11/docs
For a list of valid boot commands that you can enter at the OpenBoot prompt, type:
{0} ok help boot
boot <specifier> ( -- ) boot kernel ( default ) or other file
Examples:
boot - boot kernel from default device.
Factory default is to boot
from DISK if present, otherwise from NET.
boot net - boot kernel from network
boot cdrom - boot kernel from CD-ROM
boot disk1:h - boot from disk1 partition h
boot tape - boot default file from tape
boot disk myunix -as - boot myunix from disk with flags "-as"
dload <filename> ( addr -- ) debug load of file over network at address
Examples:
4000 dload /export/root/foo/test
?go - if executable program, execute it
or if Forth program, compile it
6. During the installation, supply the configuration parameters as directed.
See “Oracle Solaris OS Configuration Parameters” on page 76 .
Related Information
■
“Configure the Preinstalled OS” on page 71
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 72
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 74
■
“Assign a Static IP Address to the NET MGT Port” on page 77
Powering On the Server for the First Time 73