Oracle sparc M5-32, Installation Manual

Page: 166 / 182

156 SPARC M5-32 and SPARC M6-32 Servers Installation Guide • December 2014
Oracle Solaris OS Configuration
Parameters
When configuring the Oracle Solaris OS, you will be prompted for the following
configuration parameters. For more information about these settings, refer to the
Oracle Solaris documentation.
Parameter Description
Language Select a number from the displayed languages list.
Locale Select a number from the displayed locale list.
Terminal Type Select a terminal type that corresponds with your terminal device.
Network? Select Yes.
Multiple Network Interfaces Select the network interfaces that you plan to configure. If you are not sure,
select the first one in the list.
DHCP? Select Yes or No according to your network environment.
Host Name Type the host name for the server.
IP Address Type the IP address for this Ethernet interface.
Subnet? Select Yes or No according to your network environment.
Subnet Netmask If your answer to Subnet? was Yes, type the netmask for the subnet for your
network environment.
IPv6? Specify whether or not to use IPv6. If you are not sure, select No to
configure the Ethernet interface for IPv4.
Security Policy Select either standard UNIX security (no) or Kerberos Security (Yes). If you
are not sure, select No.
Confirm When prompted, review the onscreen information and change it if needed.
Otherwise, continue.
Name Service Select the name service according to your network environment.
Note - If you select a name service other than None, you will be prompted
for additional name service configuration information.
NFSv4 Domain Name Select the type of domain name configuration according to your
environment. If you are not sure, select
Use the NFSv4 domain
derived by the system
.
Time Zone (Continent) Select your continent.
Time Zone (Country or Region) Select your country or region.