To Create an Alias for a Bootable Drive (SPARC)
{0} ok
show-children
MPT Version 2.00, Firmware Version 4.00.00.00
Target 9
<...>Unit 0 Disk SEAGATE ST914602SSUN146G0603 286739329 Blocks, 146 GB
SASAddress 5000c5000b305b4d PhyNum 0
Target a
Unit 0 Disk SEAGATE ST914602SSUN146G0603 286739329 Blocks, 146 GB
SASAddress 5000c5000b304cad PhyNum 1
Target b
Unit 0 Disk HITACHI H101414SCSUN146GSA23 286739329 Blocks, 146 GB
SASAddress 5000cca000310015 PhyNum 2
Target c
Unit 0 Disk HITACHI H101414SCSUN146GSA23 286739329 Blocks, 146 GB
SASAddress 5000cca0002cf035 PhyNum 3
2.
Use the
create-raid0-volume
,
create-raid1-volume
, or
create-raid10-volume
command to create a RAID volume from the physical disks.
Note -
The only volumes supported by the HBA are volumes created with size
MAX
(the volumes
use the maximum drive space possible). Volumes using less than the maximum space of the
smallest physical drive in the volume are not supported.
{0} ok
9 a create-raid0-volume
-- for RAID 0, with targets 9 and a --
{0} ok
9 a b c create-raid10-volume
-- for RAID 10 with targets 9, a, b, and c --
3.
“Creating an Alias for a Bootable Drive (SPARC)” on page 30
.
Creating an Alias for a Bootable Drive (SPARC)
This section describes how to create an alias for a bootable drive in order to help simplify the
process of booting the drive. This section contains the following topic:
■
“To Create an Alias for a Bootable Drive (SPARC)” on page 30
To Create an Alias for a Bootable Drive (SPARC)
Perform the steps in this section to help simplify the process of booting a drive on a SPARC
system.
30
Sun Storage 6 Gb SAS PCIe HBA, Internal Installation Guide For HBA Models SGX-SAS6-INT-Z and SG-SAS6-INT-Z
• May 2017
Summary of Contents for SG-SAS6-INT-Z
Page 2: ......