Oracle Netra SPARC S7-2, Service Manual

Page: 29 / 258

Identify Disabled Components
Related Information
■
“Log In to Oracle ILOM (Service)” on page 26
■
“Identify Disabled Components” on page 29
■
“Device Paths” on page 20
■
“Interpreting LEDs” on page 30
Identify Disabled Components
You can run the
show disabled
command from the Oracle ILOM prompt to identify
components that have been disabled either intentionally, by a user, or automatically, because of
a fault.
1. At the Oracle ILOM prompt, type:
-> show disabled
Target | Property | Value
-----------------------------------+----------------+--------------------
...
/SYS/MB/CMP0 | disable_reason | Configuration Rules
...
2.
For additional information about a disabled component, type the
show -t
command and the Oracle ILOM target.
See “Device Paths” on page 20 .
For example, type:
-> show -t /SYS/MB/CMP0/MCU0/CH1/D0/
Target | Property | Value
-----------------------------------+------------------------+------------
...
/SYS/MB/CMP0/MCU0/CH1/D0 | type | DIMM
/SYS/MB/CMP0/MCU0/CH1/D0 | ipmi name | P0/M0/C1/D0
/SYS/MB/CMP0/MCU0/CH1/D0 | requested_config_state | Enabled
/SYS/MB/CMP0/MCU0/CH1/D0 | current_config_state | Enabled
/SYS/MB/CMP0/MCU0/CH1/D0 | disable_reason | Configuration Rules
/SYS/MB/CMP0/MCU0/CH1/D0 | fru_name | 32768MB DDR4 SDRAM DIMM
...
The target system paths here are examples. Your paths will vary.
Detecting and Managing Faults 29