Oracle Netra SPARC S7-2, Installation Manual

Page: 88 / 102

Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)
For more information, refer to the section on comparing installation methods in Installing
Oracle Solaris 11 Systems that corresponds to your desired release at:
http://www.oracle.com/goto/solaris11/docs
For a list of valid boot commands that you can enter at the OpenBoot prompt, type:
{0} ok help boot
boot <specifier> ( -- ) boot kernel ( default ) or other file
Examples:
boot - boot kernel from default device.
Factory default is to boot
from DISK if present, otherwise from NET.
boot net - boot kernel from network
boot cdrom - boot kernel from CD-ROM
boot disk1:h - boot from disk1 partition h
boot tape - boot default file from tape
boot disk myunix -as - boot myunix from disk with flags "-as"
dload <filename> ( addr -- ) debug load of file over network at address
Examples:
4000 dload /export/root/foo/test
?go - if executable program, execute it
or if Forth program, compile it
6. During the installation, supply the configuration parameters as directed.
See “Oracle Solaris OS Configuration Parameters” on page 91 .
Related Information
■
“Configure the Preinstalled OS” on page 86
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 87
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 88
■
“Assign a Static IP Address to the NET MGT Port” on page 92
Reach a State to Install a Fresh OS (Oracle ILOM
Web Interface)
If you do not plan to use the preinstalled OS, use this procedure to prevent the server from
booting from the preinstalled OS.
1. Prepare the appropriate boot media according to your installation method.
88 Netra SPARC S7-2 Server Installation Guide • January 2017